HB high-power reducer

If the HB high-power reducer is used for a long time, it may produce various vibration noises and other situations. When this happens, it indicates that the internal parts of the HB high-power reducer are damaged and need to be repaired or replaced in a timely manner. Otherwise, the problem will become increasingly serious and cause irreparable losses.

1. The wear of HB high-power reducer mainly includes tooth surface wear, gear tooth breakage, gear shaft hole or keyway wear.
2. Wear at the bearing hole, screw hole thread failure.
3. Wear of keyway and bending of shaft surface a.
For the wear of surfaces such as shaft faces, shaft holes, keyways, etc., electroplating can be used to restore the original part accuracy. The bending of the shaft can also be straightened using a press machine. For damages such as gear tooth breakage, there is no other way but to reprocess new parts. These are just remedial measures after the fact. To ensure the service life of the HB high-power reducer, the key is to choose the right type when purchasing, ensure a high safety factor, strictly follow the instructions for use, ensure lubrication, and avoid overload.